This is an old revision of the document!
This component of the Cart3D tutorial will walk through the process of generating an unintersected component wireframe in VSP and then using Cart3D's intersect utility to process the geometry into a single watertight body.
Although Cart3D's intersect tool is very robust, there are some cases it does not handle. One of these cases is when surfaces of two components are perfectly coincident. This situation occurs at the wing root of the Onera M6 model created in the tutorial; the root surface of the left and right wing halves are perfectly coincident.
One common fix for this situation would be to move the components slightly (say 10^-6) in the spanwise direction so the root surfaces are no longer coincident. Since the wing roots are normally buried inside a fuselage component, the gap between the wing halves would be insignificant. However, the Onera M6 geometry has no fuselage and any positive offset would result in a gap between the wings and any negative offset would result in intersection artifacts at the wing root. Furthermore, demonstrating the intersect tool with two components that don't really intersect is not very useful.
Consequently, for this part of the tutorial, a pod component will be added to the geometry to play the role of a fuselage in the model. This obviously would not be appropriate for matching the Onera M6 wind tunnel results, but it should do well for the purposes of this tutorial.
Cart3D's intersect tool is used to intersect the triangulated components and create a single watertight body. This tool is more thoroughly documented in the Cart3D documentation.