User Tools

Site Tools


tutsetup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
tutsetup [2012/02/16 13:37]
ramcdona
tutsetup [2012/02/27 22:37]
ramcdona [Next Steps]
Line 5: Line 5:
 Cart3D v1.4 includes an adjoint based mesh adaptation capability which is extremely effective at efficiently generating a mesh which is good for your purposes. ​ In this example, we will use adjoint based adaptation with drag coefficient as the adaptation functional. Cart3D v1.4 includes an adjoint based mesh adaptation capability which is extremely effective at efficiently generating a mesh which is good for your purposes. ​ In this example, we will use adjoint based adaptation with drag coefficient as the adaptation functional.
  
 +The Cart3D v1.4 adjoint calculation capability is not available on MPI-based clusters. ​ If you have a large case to run with the adjoint calculation,​ you must use a shared memory computer. ​ This tutorial example should run acceptably on a modern laptop.
 ==== input.cntl ==== ==== input.cntl ====
  
Line 150: Line 151:
 Once you have these input files set up for your case, proceed to the [[TutRunCart3D|Cart3D Execution]] tutorial. Once you have these input files set up for your case, proceed to the [[TutRunCart3D|Cart3D Execution]] tutorial.
  
 +Or, feel free to jump to your topic of choice.
  
 +  - [[OneraM6|Geometry Generation]]
 +  - [[MeshOverview|Mesh Generation]]
 +    * [[TutGenMesh|Isotropic Generated Mesh]]
 +    * [[TutUnint|Unintersected Component Wireframe]]
 +    * [[TutCompGeom|Intersected Component Wireframe]]
 +  - [[TutSTLtoTRI|STL to TRI Conversion]]
 +  - Cart3D Setup (This Page)
 +  - [[TutRunCart3D|Cart3D Execution]]
tutsetup.txt ยท Last modified: 2018/04/01 14:41 (external edit)